KitchenAid W10300928B Add Rinse Aid, Select a Cycle cycles vary by model, Start or Resume a Cycle

Pre-Wash

Main Wash

NOTE: Fill amounts shown	Hard Water
are for standard powdered
	Soft Water	Hard Water
detergent. Follow		Soft Water

instructions on the package when using other dishwasher detergent types.

Premeasured forms are suitable for all hardness and soil levels. Always place premeasured detergents in the main compartment and close the lid.

Add Rinse Aid

■Your dishwasher is designed to use rinse aid for good drying performance. Without rinse aid your dishes and dishwasher interior will have excessive moisture. The Heat Dry option will not perform as well without rinse aid.

■ Rinse aid keeps water from forming droplets that can	Full
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
■ Rinse aid helps to reduce excess moisture on the dish	Add
racks and interior of your dishwasher.

■Check the rinse aid indicator. Add rinse aid when indicator drops to “Add” level.

■ To add rinse aid, turn the dispenser cap			Lock
to “Refill” and lift off. Pour rinse aid into
the opening until the indicator level is at			-		5
“Full.” Replace the dispenser cap and				-
			-				43
turn to “Lock.” Make sure cap is fully		max	fill
	Refill							2
locked.		-						1
		-
		-						-
		-
			-				-
				-	-	-

STEP 3

Select a Cycle (cycles vary by model)

See “Cycle and Option Descriptions” charts in the following section.

Efficient dishwashers run longer to save water and energy, just like driving a car slower saves on gas. Typical cycle time is approximately 2 1/2 hours, but can take less or more time to complete depending on selections.

Select Options (options vary by model)

See “Cycle and Option Descriptions” charts in the following section.

You can customize your cycles by pressing the options desired. If you change your mind, press the option again to turn off the option, or select a different option. Not all options are available for every cycle. If an invalid option is selected for a given cycle, the lights will flash.

STEP 4

Start or Resume a Cycle

■Run hot water at the sink nearest your dishwasher until the water is hot. Turn off water.

■ Select the wash cycle and options desired OR press START/RESUME to repeat the same cycle and

NOTE: For most water conditions, the factory setting of 2 will give good results. If you have hard water or notice rings or spots, try a higher setting. Turn the arrow adjuster inside the dispenser by either using your fingers or inserting a flat-blade screwdriver into the center of the arrow and turning.

¹⁄₄ turn to lock

	-	-	6	5	4
	-
	fill
max					3
						2
-						1
-
-						-
-
	-				-
		-	-	- -
	-

options as in the previous wash cycle. Press START/ RESUME once to show which selections you used, the press START/RESUME again to start the cycle.

IMPORTANT: If anyone opens the door (such as, adding a dish, even during the Delay Hours option), the START/RESUME button must be pressed each time.

■If the START/RESUME button is located on top of door: Push door firmly closed within 3 seconds of pressing START/ RESUME. If the door is not closed within 3 seconds, the start button LED will flash, an audible tone will be heard, and the cycle will not start.

7