iin Carefully till washer backward Jnlil front of washer is
12 Use legs and ntis from pads n package. Screw nut down to
vithln l/2” of base.
13 n
nseri legs into :orrecl holes al lath front comer d washer until butstouch washer. )o not tiahlen nuis
Panel C
14 Tilt washer backward and H remove wood brace.
Genlly lower washer to floor.
Move washer to Its flnal locatlon. Remove cardboard or hardboard from under washer.
Slide washer onto cardboard or hardboard before moving across floor.
Failure lo do so may cause damage to floor covering.
adjust rear
1
icrew Ihe front legs up or down lo adjust. Make final check with level.
Nhen washer is level, use Nrench to turn nuts on front leg! JP tightly against washer base. f nuts are not tight against w&y?; base, tha washer may
Property Damage
Secure the drain hose to the tub or standplpe with the shlpplng strap removed from the back of the washer.
Failure to properly secure drain hose could result In waler damage.
6
I
Nleasure and mark a poinf approximalely li 5 inches from Ihe plug end of the sllipping strap. Cul the shipping slrap al tt lis point.
C heck that hose Is not twlsted or kiInked and Is securely In place.
F‘ul “hook”end of drain hose in tub or
Slandpipe. Tightly wrap the shipping sfrap around the drain hose and tub or
Standpipe or inlet hose as shown in F‘igures
mD u
Check that hose is not twisted or kinked and Is securely In place.
f drain hose cannot be strapped in place, I musl be cuf exaclly lo len$h so the ‘hook” end is held lightly over Ihe edge of he tub or standpipe.
Me: I, warher Is moved Loadjurt drain horn, lha vashsr mu., ba lavalad agaln. Rapea Slap* IS-
IS. Place cardboard under Lha washer and :arefully move washor lo avoid damaging floor :overing.
18 CHECK ELECTRICAL W REQUIREMENTS. BE
SURE YOU HAVE CORRECT :LECTRICAL SUPPLY AND 3ECOMMENDED GROUNDING
qCheck lhat all oarts are no’ nstalled. See parls list, Panel A. If the1 s an extra part, go back lhrough sleps I ,ee which slep was skipped.
Turn on waler faucets and
20q check for leaks. Tighlen ouplings if lhere is leaking.
Check that you have all of
qyour tools. Check that the lipping strapwith 3 colterpins and plug as removed from Ihe back of Ihe washc Id used lo secure Ihe drain hose.
22 Untape electrical cord and W plug into grounded oullet.
23 Take a few minules and q read Ihe Use and Care
Jide to fully understand your new isher. Now start the washer and allow complele the regular cycle.
To get the most efflclent use from your washer, read your KitchenAid Use and Care Guide. Keep Installation lnstrucllons and Guide close lo washer for easy reference.