Klipsch AUDIO SYSTEM manual Control POD Features, Accessories, Troubleshooting

Volume Control Programs

Some soundcard and/or PC manufacturers may have software that must be adjusted separately from the Windows volume control. Consult applicable manual for specific hardware documentation.

Subwoofer Level

For CD or DVD output, the optimum position will be indicated by the mark at 10 o'clock on the sub level control. Optimum sub levels and user preference may vary from game to game. Usually a high bass level is preferred, especially at low listening levels. Remember to reset the control set- tings before playing CDs or films on DVD.

CONTROL POD FEATURES

Headphones: The 1/8" stereo headphone output jack, located on the right-hand side of the control pod, turns off the two satellite speakers and the subwoofer output. The main volume con- trol will adjust the headphone output.

MP3/Aux: The MP3/Auxiliary input jack is used with portable audio players. This signal will be mixed with the main source. The input has a +6dB input sensitivity to help compensate for the lower output voltage of some portable players. To obtain the proper balance with the main signal, the level adjustments in the computer software and in the portable player will need to be adjusted. An example would be listening to an MP3 player while surfing the net and hearing associated sounds from various websites. The mixed sound may not be desirable, and you will ultimately determine how you use this feature.

NOTE: During playback of MP3s, overall sound quality may be perceptibly degraded compared to other audio sources such as CD. This is caused by the encoding method and quality of the MP3 file. It is recommended that MP3 files be encoded at a minimum 128 bit rate.

SPECIFICATIONS	(Visit www.klipsch.com for more details)
Satellite Impedance:	4 ohms minimum
Preamplifier Control Pod:	Subwoofer and Main volume level controls
	LED power indicator
	MP3/Aux player line input with soundcard mixing function
	Headphone jack
	Direct path interface
Satellite:	Sealed elliptical two-way enclosure with 25mm metalized
	polymer dome tweeter mated to MicroTractrixTM Horn and
	3" long-throw mid-bass driver
Subwoofer:	Bass-reflex enclosure with rear port and front-firing 8"
	long-throw driver; slot tuned port; sixth-order enclosure
	design
Amplifier:	High-efficiency Class D power section and audio quality
	transformer designed for uncompressed full
	power sound
Subwoofer Limiter:	Protective limiter function protects the driver and amplifier
	from extremely high volume playback

ACCESSORIES

All accessories are available at www.klipsch.com.

SAT-2 Speaker Stands

Telescopic floor stand for ProMedia satellites. Cast metal base, hollow tubing (allowing wire to be hidden inside). Minimum height: 28 inches. Maximum height: 48 inches.

WB-1 Wall Mount Brackets

Versatile Wall Bracket 1 is made from high quality steel. The clean, simple design affords the most extreme angle adjustment, with up to 160 degrees of movement for precise speaker positioning in the horizontal plane. Wall stud wood screws included.

TROUBLESHOOTING

If no sound, ensure that:

-Power, input, speaker cables and connectors are securely attached

-Software is properly installed and functioning

-Computer sound (control panel) volume is turned up and not muted

-LED glowing

If one or more speakers have little or no sound, ensure that:

-All cables are connected properly

-Connectors are fully "seated" in soundcard and speakers

-Main and subwoofer level controls are properly adjusted on control pod

-Computer software audio settings are adjusted for proper use

-Computer system's sound (control panel) volume is turned up

If the satellites or subwoofer exhibit distortion or buzzing:

-Turn down computer's overall volume (via control panel), and reduce control pod volume

-Turn down subwoofer’s volume, as program signal may be too strong

-Plug the subwoofer’s power cord into a surge protector

If there is noise or hissing and the volume is low even when the main volume is turned up:

-Turn up computer's sound volume (via control panel)

-Turn down main volume on control pod to compensate

-Ensure that software/hardware is properly installed and operating

If there is computer monitor interference:

-Make sure the subwoofer is positioned at least 3 feet (1m) from the computer monitor

-Increase the distance between the satellite speakers and the computer monitor

For more detailed information and FAQs, please visit www.klipsch.com.

FCC and Canada EMC Statements

Approved under the verification provision of FCC Part 15 as a Class B Digital Device.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.