5.Insert the speaker into the cutout hole. With a #2 Phillips screw- driver, tighten the four dog clamps until they are seated securely against the ceiling surface. Do not overtighten.
6.For installations using 70v/100v input connection, set the switch on the front panel to "70V/100V".
For low impedance, stereo applications, the switch should be set to 8 ohms stereo.
For low impedance, mono applications, the switch should be set to 4 ohm mono.
In all cases, please make sure the speaker wires are connect- ed to the appropriate terminal on the back.
60W 30W
70V
100V
60W 120W
IC-SW-8T2 tap selectable
7.Using the flat of your hand, insert grille into speaker frame making sure it is securely seated and flush.
Se ism ic Tab
A seismic tab, located on the back of the speaker, is used as a secondary security point. Some construction codes may require its use. To utilize the seismic tab, run a support wire from a secure point in the ceiling and attach it to the tab. Be sure to consult the construction codes in your area. Klipsch recommends the use of this tab in all installations as a secondary means of support.
