Klipsch P-37F Preparing the Loudspeaker, Connection Procedure, Fitting and Removing the Grilles

Preparing the Loudspeaker

Connection Procedure:

There is a specific procedure to be followed:

•Switch off and unplug the amplifier/s and all source electronics from the mains power.

•Place both loudspeakers in the general area where you want them.

•Connect each loudspeaker following the instructions under the “connecting the loudspeakers” section of this manual.

•Attach the spikes, following the instructions under the “finalizing the assembly” section of this manual

•Run both sets of loudspeaker cable to the amplifier

•Connect the amplifier

•Finalize the position of the loudspeakers.

•Finally, fit the grilles (if desired)

TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE LOUDSPEAKERS AROUND.

TO PRESERVE THE FINISH, WHEN HANDLING YOUR SPEAKERS, USE THE GLOVES THAT ARE PROVIDED.

Fitting and Removing the Grilles

The grilles are magnetically attached to the cabinet. Specially designed magnets are housed inside the front wall of the loudspeaker, so that if you wish to operate the loudspeaker with the grilles removed, no grille mounting hardware is visible. This preserves the smooth lines of the loudspeaker.

To fit the grilles: Fit the top grille first and line it up with the top and sides of the cabinet. For the P-38F, P-37F and P-17B there is a small lip on the top of the grille that should rest on the top of the cabinet. Now, fit the lower grille, lining up the top of the lower grille with the bottom of the upper grille. You may now remove the top grille if you wish. (The P-17B, P-27C and P-27S have a single one-piece grille only.)

Although operating the loudspeakers with the grilles on or off is a matter

of personal taste, moving or connecting the loudspeakers should always be done with the grilles removed. Be especially careful not to touch the drive units.

Page 5