Knoll HDMIDA8 specifications Installation Instructions, Features, Specifications, Warranty

Models: HSMIDA4 HDMIDA8 HDMIDA2

1 2
Download 2 pages 21.97 Kb
Page 1
Image 1
Specifications:

Specifications:

Models and Dimensions

HDMIDA2 one input two outputs

2.5” w x 3/4” h x 2-3/8” deep (6.3 x 1.9 x 6 cm)

HSMIDA4 one input and four outputs

6.5” w x 1” h x 3-1/4” deep (16.5 x 2.5 x 8.3 cm)

HDMIDA8 one input and eight outputs

12-5/8 w x 1.75” h x 4-1/8” deep (32 x 4.5 x 10.6 cm)

Power:

5 VDC 1000 mA.

Warranty

Knoll Systems warrants its products sold in the USA and Canada by authorized Knoll dealers to be free of defects in materials and workmanship. This warranty extends for three full years from the date of purchase by the original consumer. Any products returned to Knoll Systems and found to be defective by Knoll Systems within the warranty period will be repaired or replaced at Knoll Systems option, at no charge. Knoll Systems will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights. You may have additional legal rights that vary from state to state.

Knoll Systems www.knollsystems.com

145 Tyee Drive Point Roberts, WA 98281

15-7163 Vantage Way, Delta Bc V4G 1N1

Tel. (604) 940 1689, fax (855) 734 3363

Made in China Knoll Systems All Rights Reserved

HDMIDA2

TWO OUTPUT

DISTRIBUTION

AMPLIFIER

Installation Instructions v1.2

Warning: To be installed and/or used in accordance with appropriate electrical codes and regulations. If you are not sure about any part of these instructions, consult a qualified electrician.

Introduction: Thank you for your purchase of a Knoll HDMI distribution amplifier. This DA will take any HDMI signal and distribute it one or two outputs. Up to 4 HDMIDA8’s (8 output distribution amps) can be plugged into one HDMIDA2 giving as many as 16 outputs. Knoll HDMI distribution amplifiers can be cascaded twice for up to 512 outputs from 73 HDMIDA8’s.

The maximum wire length for HDMI cables is about 15 meters or 50 feet. If longer wire runs are needed so the Knoll HDMI balun solutions to allow wire runs up to 35 meters or 120 feet.

Features:

Newest version is 8 bit 3D capable with wider bandwidth.

Tabletop box design.

Will safely send 480i/p, 720p and 1080i/p signals.

Easy to use. Installs in seconds and there are no user adjustments.

Can be cascaded two times to give a maximum of 512 HDMI outputs.

Supports all HDCP forms.

Power supply included.

Page 1
Image 1
Knoll HDMIDA8, HDMIDA2, HSMIDA4 specifications Installation Instructions, Features, Specifications, Warranty