Knoll Systems HDP2300 Rear view

Rear view
ITEM LABEL DESCRIPTION SEE PAGE:
1. VIDEO Connect the composite cable from a video device
2. YPbPr Connect a component video enabled device
3. HDMI 1/ 2/ 3 Connect the HDMI CABLE from a HDMI device
4. USB Connect the USB cable from a computer
12
5. IR receiver Receive IR signal from remote control 8
Red Error code
Lamp is not ready (warming up/shutting
down/cooling)
(see LED Error Messages on page
6. LAMP LED
Flashing
40)
– 5 –
7. TEMP LED Red Error code 40
Orange Standby
Green In normal operation
8. PWR LED
Flashing Powering on/ cooling
Turns the projector on or off (main power switch must be
turned on first).
Press to place the projector in standby mode.
15
9. POWER
12
10. RS-232C Connects RS-232 serial port cable for remote control
When connected to the screen through a commercially avail-
able cable, the screen deploys automatically on start up of
the projector. The screen retracts when the projector is pow-
ered off (see notes below).
33
11. 12V OUT A/ B
Note:
y To use this feature, you must turn on the Screen Trigger function on the OSD.
y Screen controllers are supplied and supported by screen manufacturers.
y Do not use this jack for anything other than intended use.
HDP2300 Users Manual