6.
Use a screwdriver to remove
the screws from the lamp
module.
7.
Pull out the lamp module.
8.
Reverse steps 1 to 7 to install
the new lamp module.
While installing, align the
lamp module with the
connector and ensure it is
level to avoid damage.
Note:
The lamp module must sit
securely in place and the
lamp connector must be
connected properly before
tightening the screws.
9.
Turn on the projector and reset the lamp after the lamp module is replaced.
Lamp Reset:
Press Menu → Select SYSTEM SETUP : Advanced → Select Lamp → Select Lamp Mode or
Reset Lamp Timer → Press the ◄► buttons to adjust the settings.
– 36 –
HDP2300 Users Manual