IR320 Infrared Receiver Specifications:
Specifications |
|
Infrared carrier frequency: | |
Indoor reception range: | 100 feet (30 meters) max. |
Nominal reception angle: | 50 degrees off axis |
Maximum wire length: | 1000’ (300m) or even more with |
| larger gauge wire |
Wire requirements: | 3 conductors, minimum |
| to 200’; |
| |
Power requirements: | 12VDC, 40mA |
Dimensions: | 15/19” x 3/8” x 1/2" h |
| (24 mm x 10 mm x 13mm h) |
Requires 12VDC power supply, emitter(s) and a connection block.
Warranty
Knoll Systems warrants its products (with certain exceptions) sold in the USA and Canada by authorized Knoll dealers to be free of defects in materials and workmanship. This warranty extends for three full years from the date of purchase by the original consumer. Any products returned to Knoll Systems and found to be defective by Knoll Systems within the warranty period will be repaired or replaced at Knoll Systems option, at no charge. Knoll Systems will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights. You may have additional legal rights that vary from
IR320
Micro Infrared Receiver
Installation Instructions v1.0
Warning: To be installed and/or used in accordance with appropriate electrical codes and regulations.
Introduction: Thank you for your purchase of a Knoll IR320 infrared receiver. This receiver features the ability to pick up a remote control infrared signal and relay it on wires to the inside of a cupboard or to another location up to 1000’ (or more).
Actual size
Features:
∙Very small design.
∙More forgiving than previous designs and can work short distances in direct sunlight.
∙Will relay almost all remote control types.
∙Requires very little power. Suggest using Knoll PS1205 for up to ten IR320’s.
∙Up to ten Knoll infrared receivers can be connected in a single system.
∙Available in black, white and silver colors.
∙Connects with a three wire connector or 3.5mm plug.
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
Made in Canada Knoll Systems All Rights Reserved
Installation Tips
1.Follow all local electrical & building code requirements.
2.The IR320 is usually mounted to the wall or cabinet using the included double sided tape. For easy installation and to ensure reliability, it is suggested to use a Knoll PS1205 power supply, Knoll single or dual emitters and a Knoll connection block or hub.