UNDER THE CABINET INSTALLATION REAR VENT
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.
-Decide the location of the venting pipe from the hood to the outside. Refe
-A straight, short venting run will allow the hood to perform more efficient
-Try to avoid as many transitions, elbows, and long run as possible. This the performance of the hood.
-Temporarily wire the hood to test for proper operation before installing.
-Peel protective film off the hood (if any).
-For installing under the cabinet with recessed bottom, attach
-Measure and create access opening for electrical wires under the cabinet or opening for the electrical wires at the rear of the hood.
-Remove the screws on the vent cover (rear) and cut along the line of the in cover (rear) opening. Refer to Figure 8.
-Cut the vent cover (rear) opening and reverse to the other side. Refer to Reattach the vent cover (rear).
Figure 6
Inner Vent | Reversed |
| Cover (Rear) |
Figure 8
Hood Installation
CAUTION: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
8