2.Peel protective film off the duct covers and the hood (if any).
3.If necessary, remove the rubber stand at the back of the hood and store in case of future use. (For a more secure installation, KOBE recommends not removing the rubber stands.) Refer to Figure 3.
4.Place rubber seal on hood venting area; making sure the holes on rubber seal and vent area are aligned. Refer to Figure 4.
5.Pull power cord through the electrical opening on plastic damper. Refer to Figure 5.
6.Place plastic damper on rubber seal and attach to hood with seven ST 3.9 x 16 mm screws (provided).
7.Adjust height of duct cover and secure using two ST 3.5 x 8 mm screws (provided). Refer to Figure 6 and Figure 7.
5
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
