Figure 3
2.NOTE: Be careful when using electrical screwdriver, damage on the hood might Unscrew the six screws on the bottom casing. Remove the bottom casing as show Figure 4. If necessary, arrange the electrical wire to run through the 1 dia the hood.
3.Using references on Table 1 and measurement on page 16 center the hood in plac beneath the cabinet and flush with the front of the cabinet. Refer to Figure
Figure 4
4.Draw electrical wires through cabinet access opening
5.Place screws (not provided) into the exact center of each hole. Make sure all in place before tightening screws. CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING.
Ductwork Installation
6.Use aluminum or steel pipe to connect the plastic exhaust on the hood to the d above. Use duct tape to make all joints secure and air tight.
Wiring to Power Supply
7.Connect the electrical wires.
-If necessary to hide the electrical wire connections, push wires back into Access the wire connections underneath the hood by removing the bottom casing the six screws. Before reattaching the bottom casing, make sure wires do not between motors, impellers, or any moving parts to prevent any damage.
6
