Kodak 10/100 NIC Faceplate
D1 D2 | Kodak | |
10/100 NIC | ||
Normal | NET | |
LNK | ||
|
Mode Switches: D1 and D2 are operation mode switches; they are shown in Normal Operation Mode for printing (D1 & D2 Up).
LEDs: The GREEN LNK connectivity LED should come ON when connected. The YELLOW NET Traffic LED should blink intermittently as it detects traffic on the network. Both LEDs should remain OFF if disconnected from the network.
Ethernet Address: A unique NIC Ethernet address is assigned to each NIC (i.e. 0040C8 1234AB). The first six digits are always 00:40:C8. The last six digits are unique to each NIC.
Network Broadcasts: The NIC uses its Ethernet address to advertise itself on Macintosh via Appletalk and on Windows via NetBeui as “KDxxxxxx” where “xxxxxx” are the last six digits of the address.
NIC Operating Mode Switches
D1 | D2 | Mode | Description |
Up | Up | Normal | Default. Does not allow a telnet connection. |
|
|
| Users can print to the unit. |
|
|
|
|
Up | Down | Telnet | Allows a telnet connection to change its |
|
| Diagnostic | parameters. Users can also print. |
|
|
|
|
Down | Down | Reset to | This setting is used to reset the NIC to use |
|
| Defaults | factory default configuration parameters. |
|
|
| Refer to Appendix C in the User Guide for |
|
|
| details. |
|
|
|
|
Down | Up | Test Page | A parameter test page is generated when |
|
|
| you power cycle the printer. Print jobs are |
|
|
| not accepted. NOTE: The printer must be in |
|
|
| PostScript mode. For |
|
|
| obtain the parameters via a Telnet session. |
|
|
|
|
Power cycle the printer whenever you change switch settings. When finished with configuration, return the switches toNormal mode, then power cycle the printer again for normal printing operation.
Part Number 1C9753
Kodak 10/100 NIC Quick ConÞguration
Reference Guide
Applicable printers: Kodak XLS 8400PS, Kodak XLS 8600/8600PS, Kodak Professional 8657, Kodak Digital ScienceTM 8650/8650 PS color printers, Kodak Digital ScienceTM desktop color proofer 9000, and Kodak Digital ScienceTM DCP 9300 proofer
Kodak 10/100 User Guide References:
Ch1: Introduction/Config Overview | Ch7: Windows NT 3.51 |
Ch2: NIC Hardware Installation | Ch8: Windows NT 4.0 |
Ch3: Windows - FastManage | Ch9: Apple/Macintosh |
Ch4: Novell Netware | Ch10: Unix |
Ch5: Windows for Workgroups | Ch11: Printing |
Ch6: Windows 95 | Ch12: Troubleshooting |
Appendices:
A:Telnet Configuration Utilities
B:3rd Party Network Applications and Utilities
C:Upgrading NIC Flash Firmware
D:10/100 NIC Specifications
E:Technical Assistance
Kodak p rinter and NIC documentation and software are available on the Kodak Web site (www.kodak.com).
Important: This 10/100 NIC is configured using remote, platform specific, configuration utilitiesONLY. Configuration parameters entered via the printer front control panel and the corresponding printer front panel test print are not applicable to this 10/100 NIC.