Kodak 3000 manual Adjusting Your Images Before Printing, Adjusting the Output Size

Using Easy Print

Adjusting Your Images Before Printing

Many of the options on the Easy Print dialog box may already be set for you on the Easy Config dialog box. You can change the settings for any of the following defaults for the current file you loaded. However, the default settings return when you load the next image.

Adjusting the Output Size

Note:

•If you select the Aspect Lock check box, the correct proportions of the image will be maintained.

•If the Aspect Lock check box is selected, you need to set only either the height or the width.

1.Enter a value for the width of the image you wish to print in the Output Width box.

2.Tab to the Output Height box, and enter a value for the height of the image you wish to print. The maximum height is 100 ft.

Note: If you select the Aspect Lock check box, the output height is automatically calculated to maintain the correct image proportions.

Setting the Print Quality

You can change the output quality of your prints by moving the slider between High Productivity and Best Image Quality. However, when you move the slider to the right for Best Image Quality, the print time increases.

The center position provides the best balance of speed and quality.

Selecting the Image Source

From the Image Source list, select the input device that created the input for the image.

IMPORTANT: Select the correct input device because it is configured for the best possible color correction.

May 2000 4-3