Kodak 9500, 923, 70, 990, 900 manual E204 error reset the image address

Operating the scanner with the Multi-Feed Detector enabled

When the Multi-Feed Detector is enabled, the scanner is continuously checking documents for multi-feeds when the transport is running. When a multi-fed document is encountered, an error will be reported. The scanner will report a document as a true multi-fed document if it overlaps another document by ¾ of an inch or more.

When a multi-feed is detected, one of the following errors will occur (depending upon how the scanner is configured):

∙If the scanner is setup to stop and display an error, an E204 message will be displayed. The transport will stop and both Multi- Feed Detector indicators will be illuminated. To recover from an

E204 error:

-reset the image address

-reset the document stack

-start the transport again

∙If the scanner is setup to beep and display an error or just display an error, an E107 message will be displayed. The transport will continue to run, and both Multi-Feed Detector indicators will be illuminated. To recover from an E107 error:

-reset the image address

-reset the document stack

-press either the Enable, Calibrate or Stop button in order to reactivate the Multi-Feed Detector.

NOTES:

∙A skewed document can also trigger an E107 or E204 error. If only the Multi-Feed Detector Enable button is illuminated when an E107 or E204 error is displayed, then the document was skewed.

∙If for some reason, a document misses the Multi-Feed Detector sensor, the error situation described above will also occur (according to the setup of the scanner).

4 A-61120 March 1999