Before you start 01

7

En

Putting the batteries in the remote

• Open the battery compartment cover
and insert the batteries as shown.

Use two AA/R6P batteries and follow the
indications (

,

) inside the compartment.
Close the cover when you’re finished.

Important

Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe
the following:
• Don’t mix new and old batteries together.
• Don’t use different kinds of battery
together—although they may look similar,
different batteries may have different
voltages.
•Make sure that the plus and minus ends of
each battery match the indications in the
battery compartment.
• Remove batteries from equipment that
isn’t going to be used for a month or more.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction’s rules
that apply in your country/area.
• Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.

Hints on installation

We want you to enjoy using this product for
years to come, so please use the following
guidelines when choosing a suitable location:

Do...

• Use in a well-ventilated room.
•Place on a solid, flat, level surface, such as
a table, shelf or stereo rack.

Don’t...

• Use in a place exposed to high
temperatures or humidity, including near
radiators and other heat-generating
appliances.
•Place on a window sill or a place where the
player will be exposed to direct sunlight.
• Use in an excessively dusty or damp
environment.
• Place directly on top of an amplifier, or
other component in your stereo system
that becomes hot in use.
• Use near a television or monitor as you
may experience interference—especially if
the television uses an indoor antenna.
• Use in a kitchen or other room where the
player may be exposed to smoke or steam.
•Use on a thick rug or carpet, or cover with
cloth—this may prevent proper cooling of
the unit.
• Place on an unstable surface, or one that
is not large enough to support all four of
the unit’s feet.
DV300_KUC_EN.book 7 ページ ２００７年３月１１日　日曜日　午後８時４９分