Instructions for Kodak i200 Series Scanners
1.Power down the scanner.
2.Access the inside of the scanner by opening the scanner cover.
3.Lift up the scanner door release again and open the scanner door past the circuit board cover.
Upper imaging guide
Circuit board cover
Lower imaging guide
Replacing the Upper Imaging Guide
1.Locate the upper imaging guide.
2.Clean the upper transport area and imaging guide.
3.Remove the screw from the upper imaging guide bracket.
Upper imaging guide
Screw
Bracket
4.Slide the bracket away from the imaging guide.
5.Pull gently on the end of the imaging guide and slowly remove it from the scanner.
6.Discard the used imaging guide.
7.Remove any dust or debris from the guide track. Do not allow debris to fall into the scanner.
8.Wipe both sides of the new upper imaging guide with a fresh Staticide Wipe.
9.Dry both sides of the new upper imaging guide with a dry Staticide Wipe.
10.Align the new upper imaging guide in the guide track and slowly push it in.
11.Slide the bracket until it rests against the end of the imaging guide.
12.
Replacing the Lower Imaging Guide
1.Locate the lower imaging guide.
2.Clean the lower transport area and imaging guide.
3.Remove the screw from the lower imaging guide.
Screw
Lower imaging guide
4.Pull gently on the end of the imaging guide and slowly remove it from the scanner.
5.Discard the used imaging guide.
6.Remove any dust or debris from the guide track. Do not allow debris to fall into the scanner.
7.Wipe both sides of the new lower imaging guide with a fresh Staticide Wipe.
8.Dry both sides of the new lower imaging guide with a dry Staticide Wipe.
9.Align the new lower imaging guide in the guide track and slowly push it in.
10.
11.Close the scanner door.
Part No. 9E3724
CAT. No. 895 1048
© Eastman Kodak Company, 2004
