
WASHBASIN WITH PEDESTAL OR SEMI-PEDESTAL
INSTALLATION
Install the Basin
1.Make sure that the basin is installed by a competant installer.
Wall
Plug (x2)
Attachment
Bolt (x 2)Cold
Water
Hot
Water
2mm
2mm Card or
Polythene
Washer Nut
Offset Nut
10.Fit the basin in position over the attachment bolts
11.Adjust the offset nut until the basin is level.
12.When the basin is level, fit the washers and the nuts and secure in place.
13.Remove any excess silicone sealant.
14.Reposition the full pedestal (if required).
Install the Semi-Pedestal
Overflow
Cover
Cover Cap
Screw
2.Install the services.
3.Make sure that the hot and cold water supply pipes and the waste are installed correctly.
4.Position the pedestal and place a 2 mm thick piece of card or polythene on top of it. Place the basin on top of this and ensure it is level (not required if using semi- pedestal).
5.Mark through the positions of the fixing holes.
6.Remove the basin and drill the fixing holes.
7.Fit the wall plugs and the attachment bolts.
8.Fit the tap and waste to the basin in accordance with the manufacturer’s instructions.
Wall Plug
1.Hold the
2.Drill the holes and secure the
3.Place the overflow cover over the overflow hole in the basin (if supplied).
Apply
Silicone Sealant
(Optional)
9.Applysiliconesealanttothebackofthebasin(optional).
USER MAINTENANCE
Cleaning
Caution! Risk of product damage.
Many cleaners contain abrasive and chemical substances, and should not be used for cleaning stainless steel, enamel, plated or plastic fittings.
Kohler.com
These finishes should be cleaned using a mild washing up detergent or soap solution, rinsed and then wiped dry with a soft clean cloth.
Australia | New Zealand |
|
Phone: 1300 362 284 | Phone: 0800 564 537 (0800 KOHLER) |
|
Fax: 1300 652 284 | Fax: 0800 664 488 | |
www.au.kohler.com | www.kohler.co.nz |