Kohler 8002A manual Finish the Installation

Finish the Installation

1.With the ribs of the sprayhead facing up, attach the sprayhead to the waterway.

2.Using a 3/16” hexagonal wrench, fit the sprayhead to the waterway with the two securing screws (supplied). Do not overtighten.

3.Check the sprayhead for upward and downward movement and that is sits squarely within the concealing plate.

4.Place the nozzle membrane over the sprayhead.

5.Align the long edge of the membrane with the hinge ribs (horizontal).

Note! For optimum performance make sure that the membrane is applied evenly.

6.Applying pressure evenly, press the membrane seal into the sprayhead groove.

7.Tilt the sprayhead downward so the ribs on top of the sprayhead are exposed.

8.Insert the grooves of the sprayface over the ribs of the sprayhead.

9.Press the sprayface down to cover the sprayhead, as illustrated.

10.Tilt the sprayhead upwards to expose the setscrew holes on the bottom of the sprayhead.

Important! The setscrews must be flush with the edge of the sprayface frame. If the setscrews protrude outside of the sprayface frame, product damage will occur.

11.Using a 5/64” hexagonal wrench, turn the setscrews anti-clockwise until they are flush with the edge of the sprayface frame.

Attach the Sprayhead
	Waterway
	Sprayhead
	Securing Screws
	Nozzle
Ribs	Membrane
Groove

Attach the Sprayface

Finished Wall

Ribs

Sprayface

Setscrews

5 1067580-AN2-D 14/11/11