Housing
Flange Removal Tool
Flange
Whirlpool
Troubleshooting
NOTICE: This section is for general aid only. A Kohler Authorized Service Representative or qualified electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale distributor.
Remove the Port
Insert the flange removal tool (provided) into the opening of the port.
Place your thumb against the whirlpool wall while firmly grasping the flange removal tool. Pull the flange removal tool until the flange pulls free from the housing.
Reinstall the Port
NOTE: Do not use force when reinstalling the port.
Carefully insert the flange into the housing, then lightly push and rotate the flange until it snaps into position.
Verify the port is installed correctly. Remove and reinstall, if necessary.
Troubleshooting Table |
|
|
|
| |
User Keypad and Pump |
|
|
|
| |
Symptoms | Probable Causes | Recommended Action | |||
1. User keypad does not | A. | No power to control. | A. | Check wiring and connect power. | |
illuminate when power | B. | GFCI or RCD tripped. | B. | Reset GFCI or RCD. | |
button is pressed or outer | C. | Wiring harness from user | C. | Check wiring for proper | |
ring is rotated. | |||||
| keypad to control is loose, |
| connections. Replace wiring | ||
|
|
| |||
|
| disconnected or damaged. |
| harness if necessary. | |
| D. User keypad does not work. | D. Replace user keypad. | |||
| E. | Control does not work. | E. | Replace control. | |
2. User keypad is | A. | Control program is locked. | A. | Reset GFCI or RCD. | |
illuminated, but does not | B. | Wiring harness from user | B. | Check wiring for proper | |
respond to buttons or |
| keypad to control is loose, |
| connections. Replace wiring | |
outer ring. |
| disconnected or damaged. |
| harness if necessary. | |
| C. | User keypad does not work. | C. | Replace user keypad. | |
| D. | Control does not work. | D. Replace control. | ||
|
|
|
|
| |
|
|
|
|
| |
| 10 |
| Kohler Co. | ||
