Heater Indicator Light
Heater On/Off | Increases Flow |
|
Indicator Bar - Shows water flow volume
Power On/Off | Decreases Flow |
Turn the jet trim ring clockwise to decrease the flow.
Fill with water at least 2" (5.1 cm) above the highest jet.
Position the jet nozzles to direct
the water flow as
desired.
Lighted User Keypad
Turn the jet trim ring counterclockwise to increase the flow.
Operation
Power | Turns the whirlpool pump on and off. |
Up Arrow | Increases the water flow. |
Down Arrow | Decreases the water flow. |
Heater | Automatically engages when the whirlpool pump is powered on. Press the heater button |
| once to turn the heater off. Press the button a second time to turn the heater back on. |
Indicator Bar | Displays the water flow volume. |
|
|
Whirlpool
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTICE: Do not allow the water temperature in the whirlpool to exceed 104°F (40°C). The heater will automatically maintain the water temperature when the whirlpool is running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.
Close the drain, then fill the whirlpool to a level at least 2″ (5.1 cm) above the highest jet. Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Press the power icon to turn on the whirlpool pump and heater. Water will flow at medium volume.
Press the up or down arrow icons to increase or decrease the water flow. The indicator bar will display the water flow volume.
Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow or counterclockwise to increase the flow. If desired, position the jet nozzles to direct the water flow to maximize your
If desired, turn the heater off by pressing the heater icon. Press the button a second time to turn the heater back on.
Press the power icon a second time to turn off the whirlpool pump and heater.
NOTE: The pump and heater will automatically stop after approximately 20 minutes of continuous operation. If desired, press the power icon to reactivate the pump and heater.
Carefully exit the bath, then open the drain to empty the whirlpool.
NOTE: If the whirlpool is not operating properly, consult the ″Troubleshooting″ section of this guide before calling a qualified service representative.
| 4 | Kohler Co. |
