Kohler K-812-H2 manual Troubleshooting, Remove the Jets, Reinstall the Jets, Housing

Remove the Jets

Insert the tool hook as shown and pull the jet out of the housing. The jet should be facing up when this is done.

Troubleshooting

Reinstall the Jets

Housing

Inspect and lubricate the O-ring.

Slide the O-ring onto the first shoulder of the jet.

Insert the jet into the housing, and lightly push and rotate until it snaps in position.

NOTICE: This section is for general aid only. A Kohler Authorized Service Representative or qualified electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale distributor.

Remove the Jets

NOTE: The jet tool (provided with the whirlpool and trim kit) will allow you to remove the jets from the whirlpool.

Position the ball nozzle of the jet facing up. This will ensure the jet tool will not slip off.

With the hook of the jet too facing up, insert the jet tool into the opening of the jet and hook the inside top of the nozzle.

Grasping the jet tool firmly, place your thumb against the whirlpool wall. Pull steadily on the jet tool until the jet assembly pulls free from the hole. Be careful not to lose the O-ring.

Reinstall the Jets

NOTE: To allow easy rotation and proper operation of the jet, the O-ring must be: (1) correctly positioned,

(2) lubricated, and (3) in good condition.

Install the O-ring onto the first shoulder of the jet. Using the silicone lube packet (provided), lubricate the O-ring to prevent noisy operation of the jet.

Carefully insert the jet into the housing, then lightly push and rotate the jet until it snaps into position. Do not force the jet.

Verify the jet is installed correctly. The jet should turn smoothly both clockwise and counterclockwise. Remove and reinstall, if necessary.

Symptoms	Probable Causes		Recommended Action
1. User keypad does not	A.	No power to control.	A.	Check wiring and connect power.
illuminate when power
button is pressed or outer
ring is rotated.
	B.	GFCI or RCD tripped.	B.	Reset GFCI or RCD.
	C.	Wiring harness from user	C.	Check wiring for proper
		keypad to control is loose,		connections. Replace wiring
		disconnected or damaged.		harness if necessary.
	D. User keypad does not work.		D. Replace user keypad.
	E.	Control does not work.	E.	Replace control.

1019460-5-C 8 Kohler Co.