Troubleshooting |
| Ending usage |
If the flame goes out during use, this could have several grounds.
Attention:
In this case ALWAYS first place the regulator valve into the position OFF and return the clamping valve back into the start position 0! THEN attempt to eliminate the cause!
Defect | Cause | Remedy | |
|
|
| |
The flame | The gas container | Install a new gas | |
has gone | is empty | container. | |
out. |
|
| |
The protective | Allow the appliance | ||
| |||
| device in the | to cool down suffi- | |
| regulator valve | ciently and then | |
| has activated, the | reignite it. | |
| appliance is over- |
| |
| heated. |
| |
| Wind has blown | Wait until any dischar- | |
| the flame out | ged but unburnt gas | |
|
| has evaporated and | |
|
| then reignite it. | |
|
|
| |
| The burner head | Allow the appliance | |
| has been soiled | to cool down then | |
| by overflowing | clean the burner head | |
| foodstuffs | as described in the | |
|
| chapter "Cleaning | |
|
| and Care". | |
|
|
| |
The clam- | The catchment | Assemble the catch- | |
pling | bowl is inserted | ment bowl as descri- | |
lever | into the housing | bed in the section | |
does not | laterally. | "Commissioning". | |
engage. |
|
| |
|
|
|
•Check that burners are extinguished before disconnecting the gas container.
•Place the regulator valve into the position OFF and wait until the flame has gone out. Then return the clamping valve back into the start position 0 and always remove the gas canister.
•Replace the protective cap back onto the gas canister and then store it in a cool and dry location. The storage temperature must always lie below 50°C.
Caution:
In cars and caravans and with sufficient intense sunlight, very high temperatures can be generated!
•Place the regulator valve into the ignite position , so that the remaining gas in the gas cooker can be burnt off.
•Place the regulator valve back into the position OFF.
•Store the gas cooker in the transport case in a dry, cool and well ventilated location.
Cleaning and Care
The gas cooker should be cleaned regularly and after every use.
•Clean the housing with a damp cloth and mild detergent.
Do not submerse the appliance in water!
• The catchment bowl can be cleaned in dishwater.
Cleaning the burner head
•To dismantle the burner head, loosen the central screw and then clean the gas exit openings with a soft brush.
- 6 -