- 3-
• Avoid heat accumulation. Do not lay aluminium
foil or other grilling utensils on the grill bars. An
accumulation of heat could destroy plastic parts
as well as the non-stick coating.
• Use the Table grill KH 1602 exclusively with the
supplied thermostat.
• Take the grill plate into use ONLY when it is lying
on the catchment pan.
• Detach t he power plug and cable from the
appliance when it is not in use, when you detach
parts or before cleaning the appliance.
Operating Elements
qGrill bars
wSplatter protection shield
eConnection for power cable with thermostat
rCatchment pan
tHeat-insulated handles
yHeating element
uIndicator lamp
iThermostat
Taking it into use
Before taking the table grill into use for the first time
clean it as described in the chapter “Cleaning and
care”.
Usage / grilling may only take place with the catch-
ment pan rintended for the purpose.
The voltage of the power source must tally with the
details given on the rating plate of the appliance.
Handling the grill
A good and even heat distribution is assured by the
integrated heating element yin the grill plate.
Cleaning is made easier by the non-stick coating,
which prevents the adhesion of grillables.
• Fill the collecting pan rwith a maximum of 0.5 l
of water. You can thus prevent the burning-on of
fats falling from the grillables and make the sub-
sequent cleaning of the appliance easier.
• Install the splatter protection shield wat the rear
of the grill bars should you be grilling greasy
grillables. Additionally, it serves well as a wind-
break if being used outdoors: Insert the three
tenons of the splatter protection shield winto
the holes provided on one side of the grill bars
q. To do this, the splatter protection shield w
must be lightly flexed.
• Place the grill on an absolutely level and even
surface.
• Place the grill on a base material that is not
sensitive to heat.
• Check to ensure that the grill bars qare correctly
placed onto the catchment pan r(see Fig. ).
• First insert the power cable with thermostat i
into the appliance and then connect it to the
power source.
• Adjust the thermostat ito the desired tempera-
ture setting.The grill starts to warm up and the
indicator lamp uglows.
• As soon as the indicator lamp ugoes out the
grill has reached the adjusted temperature and
is ready for use.

Take note

Subject to the ambient temperature, it can occur that
the control lamp udoes not extinguish on thermo-
stat setting "M".
• The grill is ready for use after a heating-up pha-
se of ca. 15 minutes.
IB_KH1602_E1944_LB3 07.02.2008 13:32 Uhr Seite 3