Appliance description
qLaser appliance w ON/OFF button
e Spirit level for horizontal lines r Spirit level for vertical lines t Laser lens
y Rotating plate with degree scale u Marking arrow
i Fastening pins
o Fixing points on the laser appliance a Fixing points on the rotating plate s Battery compartment
(on the rear side)
Inserting the batteries
1.Open the battery compartment s.
2.Insert two batteries of Type AAA/LR03 into the battery compartment s. Comply with the polarity markings in the battery compartment s.
3.Close the battery compartment s.
Utilisation
Switching On and Off
1.To switch the laser appliance q on, press the ON/OFF w button.
2.To switch the laser appliance q off, press the ON/OFF w button once again.
Utilisation on a wall
1.Remove the laser appliance q from the rotating plate. The laser appliance clings to the rotating plate y magneti- cally.
2.Place the rotating plate y at the posi- tion on the wall from where you wish to draw the alignment line.
3.Secure the rotating plate y to the wall in that you take both fastening pins i from the sides of the appliance and you press them through the fixing points on the rotating plate a and into the wall (See Fig. ).
Notice:
The fastening pins i can be inserted into most upper surfaces, such as wood, plaster or mortar. Alternatively, espe- cially with other upper surfaces, you could also use adhesive tape for secu- ring the rotating plate y.
You can also secure the laser appliance
qwithout the rotating plate, in that the fastening pins i are inserted through fixing points on the laser appliance o itself.
4.Place the laser appliance q onto the rotating plate y.
5.Turn the laser appliance q with the marking arrow u into the desired direction.
6.Switch the laser appliance q on, by pressing the ON/OFF button w.
The laser beam appears on the wall in the direction of the marking arrow u.
Plumb-line
To mark a
- 2 - |
