Kompernass KH 3188 manual Items supplied, Technical Data, Workplace safety

Introduction / General safety advice for electrical power tools

QItems supplied

1 Cordless drill driver X14.4 - LI

1 Rechargeable battery pack X14.4 - LI - 1

1 Charging station X14.4 - LI - 2

1 Mains adapter X14.4 - LI - 3

1 Operating manual

1 Booklet “Warranty and Service”

QTechnical Data

No-load speed:	1st gear: n0 0 – 400 min-1
No-load speed:	2nd gear: n0 0 – 1200 min-1
Nom. voltage:	14 V
Chuck capacity:	1.0 – 10 mm
Maximum drill size:
Steel:	10 mm
Wood:	30 mm
Torque settings:	19 plus drill setting

X14.4-LI-1 rechargeable battery pack:

Type:LITHIUM-ION

Nom. voltage: 14 V

Capacity: 1300 mAh

X14.4-LI-2 charging station:

X14.4-LI-3 mains adapter:

Primary:

Nom. voltage:	100 - 240 V ~ 50 / 60 Hz
Rated current:	0.6 A
Secondary:
Nom. voltage:	16.8 V
Rated current:	0.65 A
Charging period:	Approx. 3 hrs.

Noise / vibration data:

Values determined in accordance with EN 60745 The sound pressure level (A-weighted) of the device is typically 70 dB (A). Uncertainty K=3 dB.

The sound level while working can exceed 80 dB (A).

Wear ear protection!

Total vibration (vector sum of three directions) is calculated in accordance with EN 60745:

Drilling in metal:	Vibration emission value
	ah, D= 1.944 m / s2,
	uncertainty K= 1.5 m / s2,
Screwing:	Vibration emission value
	ah= 2.101 m / s2,
	uncertainty K= 1.5 m / s2.

Warning! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circum- stances.

Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working.

General safety advice for electrical power tools

Warning! Read all the safety advice and instructions! Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury.

KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE!

1. Workplace safety

a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.

GB/IE

7