KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 6
KH4420
Before the First Use
1.The cordless hand vacuum cleaner is powered by rechargeable
2.The batteries reach their full capacity after a charging time of 24 hours. The cordless hand vacuum cleaner can be used for its full operating time when
the batteries are fully charged. Only place the appliance back in the char- ging station once the vacuum po- wer becomes noticeably weaker.
Charging
1. Insert the round plug of the power supply into the back of the charging station . Lock the plug by turning it
2. Place the charging station next to a power socket and plug the power adapter in.
The charging station can optionally be mounted on a wall with the supp- lied screws and plugs (see Chapter „Mounting the wall bracket“). Vertical screw spacing 102 mm, screw diameter 3,5 mm.
You can insert the nozzle attachment into the socket on the charging
station to store it.
3. Place the hand vacuum cleaner in the charging station .The charge indicator light lights up red and the charging process begins.
NOTE: Make certain that the on/off switch is in position "0" before starting the charging process.
Important:
•Once the charging process is comple- ted, the appliance automatically swit- ches to the charge maintenance func- tion. However, in order to avoid possi- ble damage to the batteries, do not leave the appliance constantly con- nected to the charging station .
•Only place the appliance back on the
charging station once the vacuum power becomes noticeably weaker.
Important information about the battery
In the event of a defective battery, please contact our service centre di- rectly. Please refer to the guarantee card for the Authorized Service Outlet in your country.
Mounting the Wall Bracket
1. | Bore two holes with a spacing of | ||
| ca. 102 mm. Using the wall bracket | ||
| to mark the boreholes ensures the | ||
| correct spacing. |
|
|
2. | Push the plugs | into the boreholes | |
| and screw in the lower screw until | ||
| ca. 3mm is protruding. |
| |
3. | Place the wall bracket | on the lower | |
| screw. |
|
|
4. | Guide the upper screw | through the | |
| wall bracket | and into the borehole, | |
| then screw it in. |
| |
5. | Tighten both screws | down. |
- 6 - |