Kompernass KH 4420 manual Changing and cleaning the dust filter

KH4420_VacuumCleaner_IB_UK 18.04.2007 10:31 Uhr Seite 7

KH4420

Assembly Cleaning

NOTE: Make certain that the dust filter is always inserted before using the appliance.

1. To open the dust collector		, turn the
dust collector clockwise and pull it
off the motor unit .
Make certain that the dust filter is
inserted and put the dust collector
back on. Turn the dust collector
anti-clockwise until the arrow symbol
points to the dot	on the motor
unit .
2. If the nozzle attachment		is requi-

red, insert this into the suction opening on the dust collector .

Operation

1.	Remove the hand vacuum cleaner
	from the charging station . Using
	the supplied plugs and screws the
	charging station can optionally be
	mounted on the wall.
2.	To switch the appliance on, move the
	on/off switch to the position "I".

3.After use place the on/off switch into position “O“.

4. The nozzle attachment is used to clean narrow, hard-to-reach areas. Put the assembled hand vacuum clea- ner in the charging station and start the charging process when the vacuum power is noticeably weaker.

Changing and cleaning the dust filter

To achieve the best results, empty the

dust collector			and clean the dust
filter		after every use.
1.	To open the dust collector				, turn the
	dust collector clockwise and pull it
	off the motor unit .
2.	To remove the dust filter				from the
	motor unit, turn it clockwise and pull
	it off the motor unit .
3.	Empty the dust collector .
4.	Clean the dust filter			in cold water
	and wait until it is completely dry be-
	fore putting it back on the motor unit .
5.	Place the dust filter			on the motor
	unit	. Turn the dust filter			anti-
	clockwise to attach it. Never use the
	hand vacuum cleaner without the
	dust filter		inserted.
6.	Put the dust collector			back on.
	Turn the dust collector			anti-clok-
	kwise until the arrow symbol points
	to the dot		on the motor unit .

Important! The suction opening must always be open and unblocked. Blockages lead to overheating and damage to the motor.

- 7 -