The charging station can optionally be moun- ted on a wall with the supplied screws and plugs i (see Chapter „Mounting the wall bracket“). Vertical screw spacing 102 mm, screw diameter 3,5 mm. The borehole has to fit for plug diameter 5 mm.
You can store the crevice tool 
and the
upholstery brush 
in the slots on the charging station 7.
3.Place the hand vacuum cleaner in the charging station 7.The charge indicator light 6 lights up red and the charging process begins.
Mounting the Wall Bracket
1.Bore two holes with a spacing of ca. 102 mm. Using the wall bracket 7 to mark the boreholes ensures the correct spacing.
2.Push the plugs 8 into the boreholes and screw in the lower screw 8 until ca. 3mm is protruding.
3.Place the wall bracket 7 on the lower screw.
4.Guide the upper screw 8 through the wall brak- ket 7 and into the borehole, then screw it in.
5.Tighten both screws 8 down.
NOTE:
Make certain that the on/off switch 5 is in position "0" before starting the charging process.
Important:
•Once the charging process is completed, the appliance automatically switches to the charge maintenance function. However, in order to avo- id possible damage to the batteries, do not lea- ve the appliance constantly connected to the charging station .
•Only place the appliance back on the charging station u once the vacuum power becomes noticeably weaker.
Assembly
NOTE:
Make certain that the dust filter 3 is always inser- ted before using the appliance.
1.To open the dust collector 2, turn the dust collector 2 and pull it off the motor unit 4. Make certain that the dust filter 3 is inserted and put the dust collector 2 back on. Turn the
dust collector 2 until the arrow symbol points to
the dot 
on the motor unit 4.
2.Should the crevice tool 
or the upholstery
brush 
be required, insert them into the suction opening of the dust collector 2.
Important information about the battery
In the event of a defective battery, please contact our service centre directly. Please refer to the gua- rantee card for the Authorized Service Outlet in your country.
Operation
1.Remove the hand vacuum cleaner from the char- ging station 7. Using the supplied plugs and screws 8 the charging station 7 can optionally be mounted on the wall.
2.To switch the appliance on, move the on/off switch 5 to the position "I".
3.After use place the on/off switch 5 into position “O“.
4.The crevice tool 
is used to clean narrow,
- 4 -
