Safety / Operation
To avoid danger to life from electric shock:
JA damaged drill / grinder, mains
lead or plug presents a serious dan- 
ger to life from electric shock. Check the condition of the drill / grinder, charger, mains lead, mains plug and battery pack at frequent intervals. Do not use a drill / grinder with dam- aged parts. If a dangerous situation arises pull out the mains plug from the socket immediately. Never open up the drill / grinder or equipment. Always have any repairs carried out or replace- ment parts fitted at the service centre or by an electrical equipment repair specialist.
JProtect the charger, battery pack and the drill / grinder from moisture.
JWarning! Do not use the drill / grinder with chargers or batteries other than the charger / battery pack supplied.
JWarning! Never short circuit the battery pack. Overheating, fire or destruction of the battery pack may result.
Therefore:
-Do not connect any wires to the battery pack poles.
-Take care that no metal objects (nails, screws, etc.) can short circuit the battery pack connectors.
Jm Attention! Never throw the battery pack into fire or water. Danger of explosion! Handle the battery pack with care, protect it from im- pacts and sharp blows!
Attention! To avoid the danger of injury, burning and damage to health:
JWarning! If you come into contact with the acid from the battery pack, wash off the acid thoroughly with water immediately. If acid should enter your eyes, flush them immediately with water and find a doctor immediately.
J | Caution! The tool continues to |
| rotate after it has been switched off! |
| Avoid contact with rapidly rotating |
| drill / grinder components. |
8 | GB |
JWhen you use the drill / grinder wear the following protective equipment: safety glasses and protective gloves.
To work safely:
JBefore cleaning or maintaining the charger or battery pack always pull the plug out of the mains socket.
JNever charge the battery pack if the ambient
temperature is below 10 °C or above 40 °C.
mAttention! To avoid damaging the tool or
workpiece.
JDo not allow the tool to come to a standstill by overloading it!
QOperation
QCharging the battery pack
mAttention! A battery pack that has been
unused for a while or never been charged must be charged before reuse or first use. The battery pack requires about
mAttention! Always pull out the mains plug (mains adapter 9 ) before you insert the battery pack into or take it out of the charger.
jConnect the adapter 9 to a mains socket.
jInsert the battery pack 3 into the charging cradle 8 . Make sure that the polarity of the battery pack matches that of charging cradle 8 .
jThe LED 10 lights up green whenever the bat- tery pack 3 is in the charging cradle 8 and the adapter 9 is connected to a mains socket.
JDo not use the
