Kompernass PPHSS730 manual Included items, Technical information, Workplace safety

Introduction / General safety advice for electrical power tools

Q Included items		Different uses of the device give rise to different vibra-
		tion levels and in many cases they may exceed the
1	Pendulum-action jigsaw including	values given in these instructions. It is easy to underes-
	- Dust extraction spout	timate the vibration load if the electrical power tool is
	- Allen key	used regularly in particular circumstances.
	- Chip guard
1	Guide fence	Note: If you wish to make an accurate assessment
1	Plastic case	of the vibration loads experienced during a particu-
1	Operating instructions	lar period of working, you should also take into
1	“Warranty and service” booklet	account the intervening periods of time when the
		device is switched off or is running but is not actual-
		ly in use. This can result in a much lower vibration
		load over the whole of the period of working.
2	Saw blades for wood
1	Saw blade for metal

QTechnical information

Jigsaw:	Parkside PPHSS 730
Rated voltage:	230 V ~ 50 Hz
Power consumption:	730 W
No-load speed:	max. n0 600 - 2900 min-1
Cutting depth:	max. 110 mm
Pendulum action:	3 speeds and a fine
	cutting setting
Inclined cut:	0 - 45° left / right
Protection class:	II /

Noise and vibration data:

Values determined in accordance with EN 60745. The sound pressure level (A-weighted) of the device is typically 90 dB(A). Uncertainty K=3 dB. The sound level while working can exceed 101 dB (A).

General safety advice for electrical power tools

Warning! Read all the safety advice and instructions!

Failure to observe the safety advice and instructions may result in electric shock, fire and/  or serious injury.

KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE!

Wear ear protection!

Evaluated acceleration, typical: Hand / arm vibration ah = 6,268 m / s2 Uncertainty K = 1,5 m / s2

Warning! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices.

1. Workplace safety

a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.

b)Do not work with the device in potentially explosive en- vironments in which there

are inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes.

GB/IE/CY 7