General safety advice for electrical power tools / Before first use
Always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area.
Warning! HAZARDOUS DUSTS! Working with harmful / poisonous dusts presents a danger to health for the tool operator and any persons in the vicinity.
Wear safety glasses and a dust protection mask!
JAvoid drilling paints containing lead or other substances hazardous to health.
JDo not drill or abrade materials containing asbestos. Asbestos is a known carcinogen.
JDo not drill moist materials or damp surfaces,
JWhen working always hold the device securely with both hands.
JIf the inserted tool jams, switch off the electrical power tool immediately. Be prepared for high reaction torques as they may cause kickback.
JAlways keep the device clean, dry and free of oil or grease.
QCaution utility services!
mDANGER! Ensure that you do not strike electrical cables, gas or water pipes when you are working with the electrical pow- er tool. Check a wall using a suitable detector before you drill or cut slots.
QOriginal accessories / attachments
Use only the accessories and attachments detailed in the operating instructions. The use of inserted tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury.
QHave you understood everything?
Once you have made yourself familiar with this general safety advice for electrical power tools, and with the help of the device’s operating instructions
10 GB/IE/CY
you now know about all the functions of and how to handle your electrical power tool, you are finally in a position to start work. Observing the manufac- turer‘s instructions and advice will maximise your safety while working with the device.
QBefore first use
QAttaching the auxiliary handle
For safety reasons this tool must always be used with the auxiliary handle 7 in place.
jPlace the auxiliary handle 7 on the spindle collar and bring it round into the desired position. Tighten the auxiliary handle 7 in position.
jIf necessary fit the depth stop 9 .
QInserting a tool into the chuck
Warning! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying out any work on the device.
QOpening the chuck
Note: The directions of rotation are given relative to the device being held by you in the working position / „drill chuck pointing away from you“. Your
matic spindle lock 
and is fitted with a single
sleeve chuck “Made in Germany” by .
The 
.
QTightening the chuck
After you have selected and inserted the tool and fixed the inserted tool in place by the turning the
