- 7-
➩If you do not want to start another lamination
process, turn the foil thickness switch oto ABS
(OFF) and withdraw the plug from the mains
power socket.
11. Anti-Blocking Switch (ABS)
At the start of the lamination process, the pouch
may be pulled in at an angle or jam itself inside the
appliance.
➩Turn the anti-blocking switch (ABS) oto the
position ABS.
• The laminate pouch is not pulled any further in.
➩Remove the laminate pouch.
➩Turn the anti-blocking switch (ABS) oback to
the desired foil thickness.
➩Re-start the lamination process.
12. Trimming function
Should you wish to use the trimming function on the
pouch guide q, dismantle the pouch guide q.
➩If necessary, fold the documents supports s
down.
➩Adjust the cutter attachment dso that it forms
a straight face with the foil guide rails q.
➩Slide the cutting head eto the end stop (the
cutting head ecan be slid to both ends of the
cutting rail w).
➩Flap the cutting rail wupwards with the rounded
grip and position the document on the pouch
guide q. Restrain the document by sliding the
pouch format locks rtogether until they touch
both sides of the document.
➩Use the markings on the measurement table to
align the document precisely.
➩Flap the cutting rail wdownwards so that it
engages.
➩Hold the paper in a secure position with your
left hand.
➩To trim, press the cutting head edown with
the right hand and then slide it with one pull or
push over the document.
13.Cleaning and care
Potentially fatal electrical shock:
• Never open the appliance housing. There
are no user-serviceable elements inside.
• Never submerse the appliance into water
or other liquids!
Cleaning the housing:
Clean the surface of the housing with a
slightly moistened cleaning cloth.
➩First remove the plug.
➩Allow the appliance to cool down completely.
➩Ensure that no moisture can permeate into the
appliance.
Cleaning the interior of the appliance:
With every lamination, contaminants are deposited
on the rollers inside the laminator. Over time, this re-
duces the performance of the laminator. You should
therefore clean the rollers inside the laminator after
use.
➩Prepare the appliance as described in Chapter
8 "Preparing for hot lamination", up to the point
where the green indicator lamp "Ready"
yglows.
IB_61862_ULG300A1_LB6 14.01.2011 11:49 Uhr Seite 7