ATTACHING A MINOLTA ACCESSORY FLASH UNIT

To extend the versatility of the camera, an accessory flash unit (sold separately) can be mounted on the camera. See page 154 for a list of compatible flash units. Always remove the accessory flash when the camera is not in use, and replace the accessory-shoe cap to protect the contacts.

Slide the accessory-shoe cap off as shown. Mount the flash unit on the accessory shoe by sliding it forward until it stops.

USING THE FLASH SYNC TERMINAL

The flash sync terminal allows a studio or location flash system to be connected to the camera with a standard PC cord. The terminal is compatible with both center positive (normal polarity) and center negative (positive polarity) flash units with a voltage of 400V or lower.

Unscrew the terminal cover. Securely connect the flash’s PC

cord to the flash sync terminal. Always replace the cover when the terminal is not in use.

To ensure correct exposures, use the manual exposure mode (p. 56). Set the shutter speed equal to or slower than the flash duration; refer to the flash unit’s instruction manual. If the built-

in flash is raised when another flash unit is connected to the flash sync terminal, both flash units will fire. However, the camera’s automatic flash control systems will not provide correct exposures. To use the built-in flash as a fill light, use manual flash control (p. 94).

The use of custom white balance is recommended (p. 68). When calibrating the camera, use the shutter speed and aperture settings require for the final exposure. A gray card may have to be used as the reference target with powerful flash units to reduce the intensity of the illumination. If custom white balance is not practical, use the preset daylight setting; auto white balance is not recommend- ed.

72ADVANCED RECORDING