8
Using a WAVEDRUM stand
You.can.attach.the.basket.section.of.the.Korg.ST-WD.per-
cussion.stand. to.the. MMA130,.and.plac e.a.Korg. WAVE-
DRUM.on.it.
Caution
Make.sure.that.you.fully.understand.the.following.informa-
tion.before.you.attach.a.WAVEDRUM.to.the.M MA130.
•. Do. not. at tach. anything. ot her. than. the. ST-WD. to. the.
MMA130’s.ST-WD.socket.. Doing.so. may.damage.t he.
ST-WD.socket,. or. ca use. the. system. to. fall. over. and.
cause.injury.
•. Adjust.the.height.so.that.the.highest.p oint.does.not.ex-
ceed.1.meter.(approximately.3.3.feet).when.the.WAVE-
DRUM.is.place d.on.the.b asket.section.of. the.ST-WD..
If.the.height.is.greater.than.1.mete r.(approximately.3.3.
feet),.the.system.may.fall.over.and.cause.injury.
•. Attach.the.included.stabili zer.to.the.MMA130.when.us-
ing.the. WAVEDRUM..If. this. part.is. not. attached,. the.
system.may.fall.over.and.cause.injury.
•. Do. not. transp ort. the. MMA130. with. the. ST-WD. at-
tached,.and.do.not.lift.or.transport.the.system.by.grasp-
ing.the.ST-WD.attached.to.the.MMA130.. .
If.you.do.so,.the.WAVEDRUM.might.fall,.causing.injury.
or.damage.
Attaching the ST-WD
*.You’ll.need. a.Philip s.head. screwdriver.(no.2). to.att ach.
the.ST-WD.
1.. Remove.the.cap.that.covers.the.ST-WD.socket.
Note:.Take.ca re.not.to.let.screws.o r.other.objects. fall.into.the.
hole..It.may.be.imp ossible.to.remove.t he.object.you.dro pped,.
or.the.object.might.damage.c omponents.inside.the.M MA130.
Note:.L eave.the.cap. attached. when.you’re.not. using.the. ST-
WD.
2.. Loosen.the.two.fastening.screws.locate d.on.the.rear.of.
the.MMA130.so.that.the.ST-WD.can.pass.through.
Cap
Fastening screws
3.. Remove.the.base.from.the.ST-WD,.and. insert.it.all.the.
way.into.the.ST-WD.socket.
Note:.I nsert.the.ST-WD. all.the.way.in. until.the.thic k.part.with.
the.knob. touches. the.MMA130.. If.it. is.not. fully.inser ted,.the.
system.may.tip.over.and.cause.injur y.
Don’t allow
a gap
4.. Position. the. ST-WD’s. knob. toward. the. rear. of. t he.
MMA130,.and.firmly.tighten.both.of. the.MMA130’s.fas-
tening.screws.to.ensure.that.the.ST-WD.is.sec ure.
5.. Make.sure. that.each. movable.part. of.the.MM A130.is.
firmly. fastened,. and. then. pla ce. the. WAVEDRUM. on.
the.basket..Ro tate.the.nu t.below.th e.basket.to. fasten.
the.WAVEDRUM.so.that.it.cannot.move.
Angle
adjustment knob
Nut
Basket
WAVEDRUM
Handle
Stabilizer
ST-WD
Height
adjustment knob
6.. Adjust.the.height.an d.angle.of.the.ST-WD.basket,.an d.
firmly.tighten.each.of.the.ST-WD’s.knobs .
Note:.U se.cautio n.to. make.sure. that.th e.WAVEDRUM. does.
not.fall.
Note:.A djust.the.height. to.1.meter.(approxim ately.3.3.feet).or.
lower.
1 meter or lower