Kramer Electronics manual Connecting the 6808 SDI-AES De-Embedder

Using the SDI-AES De-Embedder / SDI-AES Embedder

5.1 Connecting the 6808 SDI-AES De-Embedder

To connect the 6808 SDI-AESDe-Embedder, as the example in Figure 3 illustrates, do the following1:

1.Connect an SDI source (for example, a digital video player) to the SDI IN BNC connector.

2.Connect the SDI LOOP BNC connector (OPTIONAL) to the SDI IN BNC connector on an additional unit to increase outputs (see Figure 7).

3.Connect the AES OUTPUT A BNC connector2 (for channels 1-2) to a digital audio acceptor for channels 1 and 2 (for example, DAT-Recorder A)

4.Connect the AES OUTPUT B BNC connector2 (for channels 3-4) to a digital audio acceptor for channels 3 and 4 (for example, DAT-Recorder B)

5.Set the GROUP SELECT dipswitches to choose the audio group (see section 5￿ .2.1).

6.Connect the 12V DC power adapter to the power socket and connect the adapter to the mains electricity.

Figure 3: Connecting a 6808 SDI-AES De-Embedder

1 Switch OFF the power on each device before connecting it to your 6808. After connecting your 6808, switch on its power and then switch on the power on each device. Switching on the 6808, recalls the last status prior to powering down

2 When only one digital audio stream containing 2 audio channels is required, use either of the AES outputs, and leave the other AES output unconnected

5