Kramer Electronics 6810HDx1 user manual Operating the 6810HDxl

5 Operating the 6810HDxl

To operate the 6810HDxl as an embedder:

1.Connect the audio sources to the AUDIO IN TO EMBEDDER connectors.

2.Choose the target group by pressing the EMBEDDER GROUP SELECT button.

The display cycles through groups 1, 2, 3, 4, and –

The “–“ indicates that no group is chosen and the given channels are not

embedded.

If no audio is connected to the AES inputs, the display shows “–“.

3.The audio channels are embedded from the audio sources into the selected

groups of the SDI data stream.

If audio was already embedded in the groups of the SDI stream, it is replaced by the audio embedded by the 6810HDxl.

To operate the 6810HDxl as a de-embedder:

1.Connect the AUDIO OUT TO DE-EMBEDDER connectors to the audio acceptors.

2.Choose the source group by pressing the DE-EMBEDDER GROUP SELECT button.

The display cycles through groups 1, 2, 3, 4, and –.

The “–“ indicates that no group is chosen and the given channels are muted.

You can scroll only the groups where audio is detected (as indicated by the Audio Group Detect LEDs)

3.The audio channels are de-embedded from the selected groups of the SDI data stream to the audio acceptors.

Note: You cannot de-embed the same group for two channels at the same time.

8 6810HDxl - Operating the 6810HDxl