Kramer Electronics 7508 user manual Setting the DIP-Switches

Using Your 7508 CV/YC to SDI Converter

5.2Setting the DIP-Switches

Configure the 7508 unit by setting the DIP-switches, as shown in Table 2 and Figure 5.

Table 2: Setting the DIP-Switches

	DIP-Switch					Set as Follows:
1	Y/C	ON for Y/C source; OFF for CV source
2	RESERVED	OFF
3	PEDESTAL1	ON for pedestal (7.5 IRE offset selection for NTSC); OFF for no pedestal
		AUTO	NTSC	PAL	PAL-M		PAL-N	NTSC-4	SECAM	AUTO
4	STANDARD 1	OFF	ON	OFF	ON		OFF	ON	OFF	ON
5	STANDARD 2	OFF	OFF	ON	ON		OFF	OFF	ON	ON
6	STANDARD 3	OFF	OFF	OFF	OFF		ON	ON	ON	ON
7	RESERVED	OFF
8	PROGRAM	ON for upgrading firmware; OFF for normal use

Figure 5: DIP-Switch Settings

1 NTSC offsets the black level within the active video signal by 7.5 IRE when selected

8 KRAMER: SIMPLE CREATIVE TECHNOLOGY