T-channel Grid
Support Ring | Tile Rails | |
Screws | ||
| ||
Ceiling Tile |
| |
Figure 5: Installing the |
|
2.Place the tile rails on the tile and snap them into the two tabs on the
3.Insert a screw through each tab on the
4.Connect the speaker wires to the speaker terminals.
5.Insert the speaker into the opening and tighten the screws.
When tightening the screws, the tabs automatically turn outward, thus clamping the speaker to the wall from its rear side.
iDo not
6.Push the grille firmly into the slot in the speaker baffle.
Check that the grille is securely seated.
To remove the grille, insert two bent paper clips into the holes in the grille and carefully pull it down. Repeat this around the perimeter of the grille until it is completely removed
5.4Array Installation
When installing
9 |