Kramer Electronics T6F-23 !

Inserting Pass-through Cables

To insert the pass-through cables, for example, to connect a laptop, do the following

(see Figure 1):

1. Remove the two screws attaching the split pass-through bracket.

2. Remove the split grommet.

3. Insert the cable through the rectangular opening.

4. Open the split grommet slightly and insert the required cables.

5. Place the split bracket around the grommet and position this assembly over the Inner

Frame.

6. Place the two screws appropriately and tighten the split bracket together with the grommet

and inserted cables to the inner frame.

7. Insert the self-locking ties through the tie holes to secure the cables to the inside walls of

the enclosure.

Adjusting the Height of the Inner Frame

If needed, you can adjust the inner frame height to accommodate large or bulky cables. To

adjust, perform the following:

1. Remove the height adjustment screws, while supporting the frame from underneath with

your fingers.

2. Raise or lower the connecting surface to the required height, insert the screws, and tighten

them in place.

KRAMER ELECTRONICS LTD.

MODEL:

T6F-23

inner frame

For the latest information on our products and a list of Kramer

distributors, visit our Web site where updates to this user manual may be

found.

We welcome your questions, comments, and feedback.

Web site:

E-mail:

www.kramerelectronics.com

info@kramerel.com

SAFETY WARNING

Disconnect the unit from the power

supply before opening and servicing

P/N: 2900-300075 Rev 2