Connecting the VP-200NAK 1:2 XGA / Audio DA
7
5 Connecting the VP-200NAK 1:2 XGA / Audio DA
To connect your VP-200NAK 1:2 XGA / Audio DA, as the example in Figure 5
illustrates, do the following
1
:
1. Connect a computer graphics source to the INPUT HD15F connector.
2. Connect
2
the OUTPUT HD15F connectors to up to two acceptors, as
follows:
Connect the OUTPUT 1 connector to acceptor 1 (for example, a
display)
Connect the OUTPUT 2 connector to acceptor 2 (for example, a
projector)
3. Connect the unbalanced audio source (for example, the computer graphics
source audio) to the UNBALANCED AUDIO INPUT 3.5mm mini Jack
connector.
4. Connect the UNBALANCED AUDIO OUT 1 and OUT 2, 3.5mm mini jack
connectors, to up to two unbalanced audio acceptors (for example, power
amplifiers).
5. Connect
2
the BALANCED AUDIO OUTPUT (R1, L1 and R2, L2) terminal
block connectors to up to two balanced audio acceptors (for example, power
amplifiers).
6. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not shown in Figure 5).
7. If required, on the underside of the VP-200NAK:
Set the Hs and Vs switches
Set the ID Bit switch to ON
Adjust
3
the right and left audio signal levels
Adjust
3
the XGA EQ. level
1 Switch OFF the power on each device bef ore connecting it to your VP-200NAK. After powering up your VP-200NAK,
switch on the power on each device
2 When only one output is required, use either of the outputs, and leave the other output unconnected
3 Insert a screwdriver into the small hole and carefully rotate it, trimming the OUTPUT level