Kramer Electronics VP-725xl Table 10 defines the settings available for each application:

Configuring and Controlling the VP-725xl
25
25
8.1.5 The Geometry Screen
Figure 13 and Table 9 define the Geometry screen, allowing the user
flexibility in positioning his projector relative to the screening surface.
Figure 13: Geometry Screen
Table 9: Geometry Screen Functions
Setting Function Selection/Range Default
Application Select the output application Keystone, Anyplace or R otation Keystone
Location Select the location of the
display
Front, Ceiling, Rear or Rear ceiling Front
Horizontal Keystone Adjust the horizontal
keystone1
-40 to 40 0
Vertical Keystone Adjust the vertical keystone
2
-30 to 30 0
Diagonal Projection Move the location of each
corner of the display
separately3
Top Left, Top Right, Bottom Left,
Bottom Right or Reset (to reset
diagonal projections settings)
Top Left
Pincushion/Barrel Adjust the pincushion or
barrel appearance of the
screen4
-20 to 20 0
Rotation Rotate the display clockwise
or counterclockwise (in 1°
increments)
-180 to 180 0
Reset all Resets the geometry settings to their default val ues
Table 10 defines the settings available for each application:
Table 10: Available Settings for Each Application
Application Available Settings
Keystone Location, horizontal keystone, vertical keystone, pincushion/barrel an d Reset all
Anyplace Location, Diagonal Projection and Reset all
Rotation Location, pincushion/barrel, Rotation and Reset all
1 If the projector is located at an angle to the left or right of the screen
2 If the projector is located at an angle above or below the screen
3 Horizontally and vertically
4 For projection onto curved surfaces