Congratulations on choosing Krix
The Seismix 3 and Seismix 5 active subwoofers will complement existing Stereo or Home Theatre systems producing an increase in low frequency performance for a deep experience. The Seismix 3 and Seismix 5 are compatible with a variety of small to large sized, sealed or vented, main/satellite speakers.
Your subwoofer contains an amplifier of the highest electronic standards. Krix have introduced In Circuit Serial Programming (ICSP), meaning the microcontroller within the amplifier can be upgraded via the serial interface located internally on the amplifier module. This means as future features are developed your subwoofer can be upgraded. You would simply need
to return the amplifier module to Krix, where the upgrade would take place.
Figure 1 Back panel of subwoofer
Figure 2 Connection using Line Level signal
connection
1. Ensure the main power switch is off |
and connect the mains power cord. |
2. There are two methods which you can use |
to connect the Seismix subwoofer, either |
via the line level inputs which will require |
your stereo amplifier / AV receiver to have |
a subwoofer output facility (mono or stereo |
outputs) or via the speaker level inputs. |
Method 1: Line Level Connections |
It is recommended that you use Line Level |
connections for home theatre applications. |
Connect the SUB OUT socket(s) on your |
AV receiver to the Line Level input(s) |
which are a pair of RCA sockets located |
in the middle of the rear subwoofer panel |
(see figure 1). The SUB OUT socket on your |
AV receiver is usually mono which can be |
connected to the Seismix with one lead |
to the ‘Left (mono)’ input. If your AV receiver |
has stereo SUB OUT sockets then use dual |
Main AV Receiver
To main stereo speakers
leads, connecting these to the ‘Left and |
Right’ inputs. Refer to figure 2 for connection |
using Line Level signal. |
Method 2: Speaker Level Connections |
For stereo applications connect the Speaker |
Volume Control
Low Pass Control
Line Level Inputs
Speaker Level
Input/Outputs
Mains Power Switch
From | + - - + |
| |
or |
|
If only a single or mono
Figure 3 Connection using Speaker Level signal
To main stereo speakers
Level outputs on your main amplifier to the |
Speaker Level inputs on the rear panel of |
the Seismix (see figure 1). Then connect |
the Speaker Level outputs on the rear panel |
of the Seismix to each of your left and right |
speakers. Be sure to maintain correct phasing |
for each set of speaker leads, red (positive +) |
to (+) and black (negative |
to figure 3 for connection using Speaker |
Level signal. |
3. Before turning the Seismix on, ensure the |
volume control is turned down and set the |
Low Pass (Hz) control to the middle position |
(see figure 1). Turn on the unit with the |
power switch located at the bottom of the |
rear panel, the subwoofer will activate and |
the blue Power / Standby LED will light up. |
Begin by playing music with bass content |
and slowly increase the volume dial on the |
subwoofer to a moderate level. |
|
|
Main Stereo Amplifier | + - - + |
|