English
Thank you for purchasing this KRUPS appliance.
Whatever model you have, please read these
instructions carefully and keep them for future
Connect the Brown wire to the terminal in the plug marked “L” or coloured Red.
Connect the Blue wire to the terminal in the
InstallationCooking
reference.
Description (1)
a“On/off” light (red)
b“Ready” light (green)
cAdjustable thermostat
dHandle release button
eHandle
fRemovable waffle plates
gPlate retaining pins
hNotches for easier handling of plates
iSpill tray
j
plug marked “N” or coloured Black.
Seek professional advice if you are unsure of the correct procedure for the above.
ABOUT YOUR FACTORY FITTED PLUG
The cord is already fitted with a plug incorporating an appropriate fuse. If the plug does not fit your socket outlet, see paragraph below. Should you need to replace the fuse in the plug supplied, an appropriately rated approved BS 1362 fuse must be used (refer to electrical specification for fuse rating).
If the plug supplied does not fit your socket outlet, it should be removed from the mains lead and disposed of safely. The flexible cord insulation should be stripped back as appropriate and a suitable alternative plug fitted. The replacement plug must be equipped with an appropriate fuse. If the plug has external access to the fuse
Place the appliance on a stable, heat resistant surface: do not use it on a soft surface such as a table pad.
Do not place the appliance on or near slippery or hot surfaces. Do not let the cord hang down over a source of heat (hot plates, gas cookers, etc.).
Before using the appliance for the first time:
•Put the handle in a horizontal position (2).
•Open the appliance.
•Remove any packaging, stickers and accessories from both inside and outside the appliance.
•Pour a little oil onto the plates. Wipe with a soft cloth.
Place the spill tray (i) underneath the appliance (1).
Set the thermostat (c) to the position of your choice or as required for the recipe.
Open the appliance.
Do not touch the hot surfaces of the appliance: use the handle (e).
Use a ladle to pour waffle batter onto the bottom plate (f) of the appliance (5).
Close the appliance and press down firmly.
Wait 10 seconds then turn the appliance over, turning the handle (e) to the right
Cook the waffles for the time indicated in the recipe.
When they are cooked, turn the appliance over again, turning the handle (e) to the left
Open the appliance and remove the waffles.
For U.K. users only : additional
information and instructions
WIRING INSTRUCTIONS
WARNING: ALL APPLIANCES MUST BE EARTHED.
IMPORTANT: the wires in this lead are coloured in accordance with the following codes.
Green and Yellow : Earth
Blue: Neutral
Brown: Live
Connect the Green/Yellow wire to the terminal in the plug marked “E” (or by the earth symbol) or coloured Green.
N: Blue | E: Green and |
or black | yellow or green |
L: Brown |
or red |
Fit correct |
fuse(13 amp) |
Use cable gripper
is always refitted correctly. If you lose this cover, please do not use the plug. You may contact our helpline for a replacement.
For any problems or queries, please contact our Customer Relations Team first for expert help and advice:
0845 602 1454 – UK (calls charged at local rate) (01) 47 51947 – Ireland
Handling the plates
Check that the appliance is cold and unplugged before handling the plates.
• To remove the plates (7):
Open the appliance and hold the handle (e) with one hand. With the other hand, grasp the plate (f) at the notches (h), pull it sideways and
disengage it from the retaining pins (g) to remove it.
• To insert the plates (8):
Insert the plate (f) at an angle into the retaining
pins (g) and press on the opposite side to
secure it correctly in the appliance.
Plugging in and preheating
the appliance
Close the appliance.
Check that your electrical installation is compatible with the power and voltage shown underneath the appliance.
Plug the appliance into an earthed socket only.
If the power supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Plug the cord into a socket: the red “on/off” light (a) comes on (3).
Set the thermostat (c) to 6 and let the appliance preheat for approximately 5 minutes: when it has finished preheating, the green “ready” light (b) comes on (4).
When the appliance is used for the first time, it may give off a slight odour and smoke, this is normal.
After use
Set the thermostat to the minimum setting.
Unplug the cord.
Let the appliance cool down completely in the open position.
Clean the plates (f), the spill tray (i) and the body of the appliance with a sponge and washing up liquid.
The plates (f) and the spill tray (i) are
Do not use a metal scouring pad or scouring powder.
Never immerse the appliance or the cord in water.
Storage
To save space, press the handle release button (d) and fold the handle down (9).
8 | 9 |
