12
2.Place the glass carafe with lid in position on
the warming plate.
3.Turn « ON » your appliance in drip coffee
mode using the selector knob (S). The
indicator light will illuminate indicating that
the brewing process has begun (9).
4.As long as the blue indicator light is
illuminated the coffee will be kept warm.
Pause and Serve Feature
The Pause and Serve feature automatically
stops the flow of brewed coffee through the
filter cone if the glass carafe is removed from
the warming plate during the brewing cycle.
You have about 20 seconds between the
removal of the carafe and it being reinserted
back onto the warming plate.
The Pause and Serve device closes off the filter
cone so effectively that there is virtually no
coffee dripping onto the warming plate. Once
the carafe is replaced, the brewing process
and the flow of coffee into the carafe will
resume.
CAUTION
If significant amounts of coffee drip onto the
warming plate afer the carafe has been
removed, please check the seal in the filter
holder to ensure it is placed properly. If a
requirement seal is needed, please contact
one of our main service centers or our main
parts center.
If the filter is overfilled with coffee grounds, it
could cause the water that jets into the filter
cone to overflow between the filter and the
sides of the filter cone. Be sure to use the
proper amount of ground coffee.
If this blockage and subsequent dripping does
occur, put the glass carafe immediately back
onto the warming plate, and allow the full
brewing cycle to run its course. Do not swing
out the swivel filter until the brewing process
is completed.
Cleaning the coffeemaker
Always unplug this appliance before
cleaning. Clean the filter basket, carafe, and
lid in a solution of warm water and mild
liquid soap. These parts can also be placed in
the upper level of your dishwasher away
from the heating and drying element for
safe effective cleaning.
Never use scouring agents.
Never immerse the appliance itself in water.
To clean, simply wipe off with a soft, damp
cloth.
Never use a cloth to clean inside of the
water chamber, as this might leave residual
deposits in the chamber. Just rinse with cold
water periodically.
Decalcifying thecoffeemaker
The warranty does not cover faulty or
broken machines that are not properly
descaled.
The coffeemaker must be decalcified regularly.
The frequency depends on the hardness of
your water and how often you use the
coffeemaker.
Recognizable indications that descaling is
necessary are :
- increase noise during boiling,
- longer preparation time.
If usage is frequent, descaling should be
carried out as follows :
- with soft water once a year,
- with medium hard water every quarter year,
- with hard water once a month.
In doubt regarding the water hardness in your
area, you may call your local water
department.
As descaling agent we recommend the use of
reference solution N°F054 from Satisfusion 1
Service at 888-344-0727.
Dissolve a packet of Krups descaling solution
in 1/2 quart water and pour into the water
container. Run this through 2 or 3 times as if
making coffee, but using no ground coffee.
The hot descaling solution must be allowed to
cool down before being poured into the
water container. Finally do the same twice
using clear water.
XP1500/1530 US/F/E.PM6.5 16/03/05, 10:5212