7
Section L- Installation Instructions (continued..)
A stove top connector section may be required with reduced clearances installations
*Chimney- This room heater must be connected to either an 8” chimney complying with the requirements for Type HT chimneys in the standard for Chimneys,
*CLEARANCES- Refer to Section ‘O’ figures 2 and 3 for minimum installation clearances to combustibles. NOTE: Clearances may only be reduced by means approved by the regulatory authority.
INSTALLATION INSTRUCTIONS:
1)Set the unit on the floor protector.
2)Make sure the clearance from the unit to combustibles is according to the minimum clearances in figures 2 and 3. Also make sure of the minimum clearances from the chimney connector to combustibles.
3)Check the minimum clearances on the floor protector as per figure 4.
4)Connect the unit to the chimney with the chimney connector (stovepipe) using a slip connector usually supplied in a basic stovepipe kit.
5)Fasten the stove pipe sections together securely with screws, and screw the stovepipe to chimney connection at ceiling or wall.
6)Double check all clearances and connections before operation.
*DO NOT CONNECT THIS APPLIANCE TO A CHIMNEY
SERVING ANOTHER APPLIANCE*
*THIS STOVE IS NOT APPROVED FOR INSTALLATION INTO MOBILE HOMES*