ASSEMBLY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

Read the complete assembly instructions before starting the assembly.

You should have:

-one mower deck assembly

-two carrier arm assemblies

-two rear tire assemblies

-one front cross brace tube and one rear cross brace tube with height adjust assy.

-one ATV tongue assembly

A.ASSEMBLY OF REAR WHEELS AND CARRIER ARMS

1. Set the mower deck assembly on wood blocks so that it is suspended off the ground.

Note: The operator controls are on the front of the deck. (Left and right are determined by looking in the direction of travel or by standing at the rear of the deck assembly looking forward.)

2.Install the rear tire assemblies on the carrier arm assemblies. Remove the hex nut and lock washer from the rear tire assembly and install the 5/8”x7-1/2” tire axle bolt through the hole in the carrier arm assembly. See figure 1. Secure assembly with the lock washer and hex nut provided on the rear tire assembly. The rear tires should be offset to the outside of the deck assembly on both sides. See figure 2.

Carrier Arm

 

Rear Tire

 

Assembly

 

 

 

 

 

Bolt

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Hex Nut and

 

 

Lock Washer

Cup Washer

Flat Washer

 

Figure 1: Rear Tire Assembly Installation

4

Page 5
Image 5
Kunz MR44K, MR44B owner manual Assembly Instructions, You should have, A. Assembly Of Rear Wheels And Carrier Arms