Kustom GROOVE 310C owner manual Rear Panel, t u v w x y

Rear Panel

GROUND

MODEL: GROOVE 600

			LIFT
8A/250V					TUNER OUT
			DIRECT OUTPUT
		SPEAKER OUTPUT
		600W RMS 3 Ohm	EFFECTS LOOP
	KUSTOM INC
SERIAL NUMBER	CINCINNATI,OHIO USA
	CAUTION
	CHASSIS SURFACE HOT
120V 60Hz 1500W	ATTENTION		SEND	RETURN	FOOTSWITCH
DESIGNED IN USA	SUPERFICE DE CHASSIS CHAUDE

MADE IN CHINA

t

u

v

w

x

y

Circuit Breaker:

This circuit breaker will trip when too much current is applied to the amplifier. To reset: Turn off Power Switch, press circuit breaker button, and turn the Power Switch on. Note: If the Circuit Breaker trips repeatedly when AC power is applied, take the amplifier to an authorized service center for repair.

Power Cord:

This supplies AC power to the amplifier. If the cord becomes damaged, take the amplifier to an authorized service center for repair.

Speaker Output:

This jack is used to connect the amplifier to internal speakers, or an external speaker cabinet, using a heavy duty Speakond speaker cable. Note: To prevent overheating and possible loss of signal, do not connect a load lower than 2 ohms. (To connect a cable: Align tab on speaker cable connector slot. Insert and twist one quarter turn clockwise to lock. To remove a cable: Pull back release button on cable connector, twist connecter counter clockwise one quarter turn, and pull out connecter.)

Ground Lift Switch:

Activating this switch removes the ground connection on the Direct Output Jack. Removing the ground connection will eliminate ground related signal hum and noise.

Direct Output Jack:

This is a line level output used to connect the amplifier to another device, such as a mixer or recorder.

Pre EQ / Post EQ Switch:

When set to Pre EQ, the Direct Output Jack

z

{

}

signal will be unaltered by the EQ sections of the preamp. When set to Post EQ, the Direct Output Jack signal will reflect the entire sound (including EQ settings) of the preamp. Note: The Master Volume Control and Solo On/Off Button have no effect on the Direct Output Jack signal.

Tuner Out Jack:

Use this jack to connect to a tuner or other line level device. This jack is always active and is a pre-gain output.

Effects Send Jack:

Use this jack to connect to the input of an external effects processor. This jack can also be used as a preamp out.

Effects Return Jack:

Use this jack to connect to the output of an external effects processor. This jack can also be used as a power amp in.

Footswitch Jack:

This 3-conductor 1/4” jack may be used for connecting a footswitch to the amplifier (Footswitch model KAC-GFS100 is included with the amplifier). The footswitch will then control the Mute and Solo features.

7