KXB200H/HR Control Panel
KXB200
1.0 dB Input: ¼-inch input that is intended for bass guitars with standard, passive electronics.
2.–6 dB Input: ¼-inch input that is optimized for bass guitars with active electronics.
3.Gain: Controls the input level to the preamp. Set so Clip indicator light is not lit, otherwise distortion may occur.
4.Volume: Controls the overall volume level of the amplifier. Use in conjunction with the Gain control to obtain the desired level.
5.EQ-63:This active control adjusts the low frequencies to boost or cut by 12 dB centered at approximately 63 Hz.
6.EQ-150:This active control adjusts the low-mid frequencies to boost or cut by 12 dB centered at approximately 150
Hz.
7.EQ-350:This active control adjusts the low-mid frequencies to boost or cut by 12 dB centered at approximately 350
Hz.
8.EQ-800:This active control adjusts the hi-mid frequencies to boost or cut by 12 dB centered at approximately 800 Hz.
9.EQ-2K:This active control adjusts the high frequencies to boost or cut by 12 dB centered at approximately 2 kHz.
10.EQ-5K:This active control adjusts the high frequencies to boost or cut by 12 dB centered at approximately 5 kHz.
11.Aux In: This is a 3-conductor, 1/8-inch, stereo jack that allows playback from a Compact Disc, MP3 player or other audio device. The overall volume level will be determined by the audio device, so start with lower volume levels and increase as needed.
12.Headphones: This is a 3-conductor, 1/8-inch input jack intended for headphone use. The amplifier’s internal speaker is disconnected when this jack is used.
13.Power Switch: This dual-function component is both an On/Off power switch and a status indicator light. When illuminated, it shows that your amplifier is ready to be played. To turn amplifier on, press switch upward. To turn amp off, press switch downward.
