Kustom WAV 212 Specifications, Model, Output Power, Total Harmonic Distortion, System Gain

Models: WAV 212

1 16
Download 16 pages 57.3 Kb
Page 13
Image 13
Specifications

Specifications

Model

wAv 212

Stereo guitar amp with digital effects and selectable preamps

Input Impedance

200K Ohm

 

Output Power

60W per channel

8 Ohms @ 5% THD

Frequency Response

20HZ-20kHz

Actual response is tailored to speakers for accurate acoustical

response using a guitar as input.

 

 

 

 

Because of the intentional distortion created by using some of the

Total Harmonic Distortion

Less than 0.4%

preamps and effects, this Distortion is measured from the power

 

 

amp input signal to the output to speakers.

Hum & Noise

-50dB

Residual Noise, all level controls 0% (minimum)

System Gain

30 dB

Lead Channel, Clean Preamp output

40dB

Lead Channel, Classic Preamp output

 

All measurements taken with 1 KHz

60dB

Lead Channel, Crunch Preamp output

60dB

Lead Channel, Wave Preamp output

input signal, Tone controls flat, Gain

6dB

Lead Channel added gain for all settings with Boost on

and Volume Maximum Boost off

35dB

Rhythm Channel, Shift Out

unless noted. Measured at preamp

40dB

Rhythm Channel, Shift In

output jacks on rear unless noted.

35dB

Power amp gain

 

 

64K User Memory

 

 

18 Bit 44.1Khz sampling rate Stereo Processor with onboard firmware flash memory

 

There are 45 selectable effects separated into 3 groups of 15. One effect from each group

Digital Effects

active at the same time. Up to 3 groups active at the same time.

 

There are 12 user presets. Each preset stores all setting for the 3 groups. There are 4

 

Favorites banks. Each favorites bank contains 3 user presets. Presets in the banks are

 

selected by tracking the channel select and Lead Boost button status.

Footswitch

Use only with Model: KAC-FSWAV (supplied with amplifier)

Use any standard CAT 5 cable wired to the 568A or 568B standard

 

 

USA/Canada

120VAC/60Hz, 200W nominal

 

Europe

230VAC/50Hz, 200W nominal

Power Requirements

UK

230VAC/50Hz, 200W nominal

 

Australia

240VAC/50Hz, 200W nominal

 

Japan

100VAC/50-60Hz, 300W nominal

Dimensions

mm/kg

540 (Height) x 700 (Width) x 280 (Depth), 25.4kg

Inches/Pounds

21.25 (Height) x 27.5 (Width) x 11 (Depth), 56 lbs

 

13

Page 13
Image 13
Kustom WAV 212 Specifications, Model, Output Power, Total Harmonic Distortion, System Gain, Digital Effects, Footswitch